Victory Reach-In Servisní příručka stáhnout pdf (Strana 92)

Section 8Component Replacement Procedures

8-12

DOOR INSTALLATION

WARNING

To prevent personal injury and/or cabinet

damage, perform this procedure with two

people, each capable of lifting 75 lb. (34 kg).

1. Be sure the top and bottom hinge brackets

are securely mounted to the cabinet.

2. Be sure the top hinge pin and the

torquemaster are properly mounted to the

hinge brackets.

3. Use a standard screwdriver to carefully

pry the outer shaft retainer from the

torquemaster.

4. Slide the door up into the top hinge pin

bracket.

5. Align and engage the hold-open arm stud

on the door with the key hole on the hold-

open arm. Do not lower the door yet, or

you will bend the hold-open arm.

6. Lift up on the door and slide it into the

torquemaster on the bottom hinge bracket.

7. Install the safety snap ring on the top pin

shaft.

8. Install the outer shaft retainer on the

torquemaster.

9. Adjust the door as necessary. See Tension

Adjustment and/or Door Sag Adjustment,

both on page 8-11.

Figure 8-14: Bottom Hinge Bracket Assembly

Temperature/Humidity Chart for

Condensation On Glass Doors

Glass door refrigerators use two-pane

reflective, non-heated glass (NHG).

Condensation will form on the glass if the unit

is installed in a high humidity area.

Atmospheric conditions vary depending on

specific operating conditions. Use the chart

below as a guideline when selecting an

installation space.

Room Temperature Relative Humidity

70°F/21.1°C 76%

75°F/23.9°C 72%

80°F/26.7°C 69%

85°F/29.4°C 67%

90°F/32.2°C 65%

*Based on interior cabinet temperature of 38°F/3.3°C.

SV1503

BOTTOM HINGE

BRACKET

KEYHOLE

HOLD OPEN

ARM

DOOR SAG

ADJUSTMENT

DOOR TRAVEL (TENSION) ADJUSTMENT

TORQUEMASTER

TORQUEMASTER MOUNTING SCREW

SHAFT RETAINER

1 2 ... 87 88 89 90 91 92

Komentáře k této Příručce

Žádné komentáře